Body Shop

Body Shop: Body Align

	1. On every project that comes through our facility we refine the gaps to the best of our ability. The goal is to have the body fitted to 3/16 gaps. Depending on what the car will allow based on the factory hinges and catches we will push, pull, cut, slice and weld to achieve the results. Watch what it takes to make it happen.


	Trim is always a deciding factor on what we are able to achieve. Large gaps from pot metal trim pose many problems.
	Same on the other side
	tail pan was widened.
	We split then added to lengthen the tail pan panel

	hood is too high
	after adjustments we are now level
	spot welds were cut and the panel was raised to achieve it
	Same on the hood as it was lowered. Then all welds are redone.
	Welds ground down.
	She looks good.